1:10th FWD Touring Car

• Hobbywing Justock G3s (HW30112005) 
• ESC Firmware: ETS-FWD18-4.4.05
• Set to 17.500 RPM limiter
• LED Flash Pattern: 🔴🟢🔴🟢🔴🟢 (Red-Green alternating continuously)

• Hobbywing Justock G2.1 FTM 17.5. (Motor HW30408011)

• Maximum FDR of 5.0

• Ride RI-36086 TR09
• Only MR33 V4 or V5 Carpet Additive may be used

Any Front Wheel Drive bodyshell approved by the BRCA or ETS and meeting industry-recognised dimensions.

Only wings included with the body shells may be used, cut out, and mounted exactly as intended by the original manufacturer.

All cars must maintain a ground clearance of 5mm; no screw or fitting should protrude below the bottom of the chassis.

Ground clearance is defined as follows: the club’s 5mm gauge should be able to pass under the car from front to rear and from side to side when the car is standing in race-ready condition without the car moving.

Any movement of the car, either laterally or vertically, will be deemed a failure.

Cars must weigh a minimum of 1250 grams (including personal transponder, excluding handout transponder), ready to race, including bodyshell.

Any commercially available 2S Lipo. Solid cased racing packs only (soft cased model aircraft packs not permitted on safety grounds).

LiPo must be in a hard casing; refer to the SRCC general rules for further information on safe usage and maximum cell voltage.

Any commercially available RC equipment functioning on the 27 MHz, 40 MHz or 2.4 GHz bands is acceptable.

Any servo may be used.